Getting started

UM1479

14/28

Doc ID 022381 Rev 1

Figure 14.

SW4 upward position for connecting the coin cell

1.2.11

Post data logger stage

The post data logger stage is used to download the logged data in the computer and

compare this data.

Below are the steps for the post data logger stage:

1.

Put the switch SW4 into the downward position, as shown in Figure 11.

2.

Connect the RFID reader to the computer.

3.

Place the STEVAL-IPR002V1 on the RFID reader, as shown in Figure 12.

4.

Open the GUI application.

5.

Press the “Connect” button as shown in Figure 6. It shows the message “Board is

connected”, If the board is not connected, close the GUI, reopen it, and press the

“Connect” button again.

6.

Click on the “Download from the Data logger/Event Logger” tab as seen in the bottom

of the GUI window, as shown in Figure 15. The GUI window, as seen in Figure 8,

opens.

7.

Press the “Get DataLogger/EventLogger” button on the GUI window.

8.

The window shows the values for different sensors on the GUI. These values, as seen

on the GUI, are the last stored values of the sensors. Each sensor also has a log count

which shows the number of values logged for that sensor.

9.

Figure 8 shows the condition.

10. Click on the “Graph Plot” tab at the bottom of the GUI window.

11. This opens the plotter window shown in Figure 16. Select the sensor whose plot is to

be seen and then click the “Plot” button.

12. Double click on the plot to expand it. To exit from expanded plot, again double click on it

and it returns to step 10.