AN3213 datasheet(46/64 Pages) STMICROELECTRONICS

No. de pieza	AN3213

Descripción Electrónicos	ST7570 S-FSK power line networking system-on-chip

PDF	64 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

46 / 64 page

ST7570 demonstration board description

AN3213

46/64

Doc ID 17429 Rev 1

Figure 41.

Carrier frequency deviation vs. crystal tolerance

In order to evaluate the compliance, with the requirement of the delay between mains zero

crossing and the beginning of the communication window, the zero crossing coupling circuit

response needs to be considered, introducing a delay of 30 µs (typical) between mains zero

crossing and ZC_IN_A signal (see Section 7.1.4).

The target delay equal to 120 µs can be achieved by adding an integer number of 13 µs

steps to the circuit delay (References 2). In particular, with 7 steps the total delay is 7×13 µs

+ 30 µs

≈ 120 µs.

The jitter around the expected value changes in accordance with the crystal tolerance, as

shown in Figure 42.

Figure 42.

Delay between mains zero crossing and transmission start: jitter vs.

crystal tolerance

The maximum tolerance for the HC49U crystal adopted for the ST7570 demonstration

board, that is 150 ppm, allows the above requirements to be met.

AN3213 Datasheet(PDF) 46 Page - STMicroelectronics