H3CA

6

ON-delay Operation

Repeat Cycle Operation

t: Set time; t-a: Time within the set time

t: Set time; t-a: Time within the set time

If a check signal is input to the timer during the lapse of a set time,

the remaining set time will become 0 and the timer will enter the

next control state. Also, while a check signal is being input, the

elapsed time measurement of the set time is not performed.

Note: 1. This timing chart indicates the gate input in operation

mode A (ON-delay operation).

How to Use Gate Signal Input

How to Use Check Signal Input

H3CA-8H