AS5262

Datasheet - Detailed Descr i p ti on

www.ams.com

Revision 1.1

14 - 36

Figure 11. Overview of the Angular Output Voltage

Figure 11 gives an overview of the different ranges. The failure bands are used to indicate a wrong operation of the AS5262. This can be caused

due to a broken supply line. By using the specified load resistors, the output level will remain in these bands during a fail. It is recommended to

set the clamping level CLL above the lower failure band and the clamping level CLH below the higher failure band.

Clamping Region Low

Failure Band Low

0

4

CLL

CLH

96

100

Failure Band High

Application Region

Clamping Region High

T2Y

T1Y