AS3515_08 datasheet(36/67 Pages) AMSCO

36 / 67 page

AS3515 V15

austriamicrosystems

Data Sheet, Confidential

www.austriamicrosystems.com

Revision 3.1

- 66

6.12 SYSTEM

6.12.1 General

The system block handles the power up and power down of the AS3515.

6.12.2 Power Up

The AS3515 powers up when on of the following condition is true:

•

High signal on the PWR_UP pin (>80ms, >1V)

•

Input voltage on the UVDD pin (USB plug in: >80ms, BVDD>3V, UVDD>4.5V)

•

Input voltage on the CHG_IN pin (charger plug in: >80ms, BVDD>3V, CHG_IN>4.0V)

To hold the chip in power up mode the PwrUpHld bit in the SYSTEM register (0x20h)is set.

6.12.3 Power Down

The chip automatically shuts off if one of the following conditions arises:

•

Clearing the PwrUpHld bit in SYSTEM register (0x20h)

•

I2C watchdog power down if enabled

•

BVDD drops below the minimum threshold voltage (2.6V)

•

Junction temperature reaches maximum threshold, set in SUPERVISOR register (0x24h)

•

High signal on the PWR_UP pin for more than 11s.

Figure 15 Power Up Timing

Power up from PwrUp, CHG_IN,

UVDD or RTCSUP pin

BVDD

rising with VBAT1 supply (DCDC3V)

VREF, IREF

rising with vdd_bandgap

QLDO1 & 2

AVDD & DVDD for internal supply

Enable Startup Sequence

EN LDO2 + DCDC

start sequencer with 1.2 MHz clock

VREF=ok

QLDO2=ok

Enable PVDD

Enable CVDD

+50ms

+52ms

+54ms

PowerGood = XRES

+56ms

Enable CPVDD

AS3515 Datasheet(PDF) 36 Page - ams AG

AS3515 Datasheet(HTML) 36 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

Datasheet Descarga

Enlace URL