AS3510 datasheet(9/20 Pages) AMSCO

9 / 20 page

Product Brief AS3510

Rev. 1v2, June 2004

CONFIDENTIAL

Page 8 of 19

Supply Regulator

Block Description

This block can be used to provide three regulated supply

voltages for the

on_chip digital section

on_chip analog section

external circuit (uP, DSP…)

from the battery supply BVDD which is directly used by the

power_amplifier.

The LDO1 and LDO2 do have the capability to drive 50mA

with a voltage drop of <=50mV (1Ohm). Since the nominal

output voltage for these LDOs is 2.9V (+/-50mV), a

regulation can be done with BVDD as low as 3.0V.

The LDO3 is used to generate a supply voltage PVDD for

the peripheral cells and external digital circuits, which are

controlling the inputs of the AS3510. The drive capability is

≥200mA with a BVDD≥3V.

The maximum output currents for these LDOs can be

calculated using the following equation:

Ohm

Vout

BVDD

)

(

max

−

Vout is 2.9V for LDO1 and LDO2. The output Voltage for

LDO3 can be programmed via the PLDO3 pin.

PLD3 pin

QLDO3 voltage

VSS

2.25V

150k to VSS

2.0V

open

2.5

150k to DVDD

1.5

DVDD

1.75

Table 10

LDO3 Programming

There are two pads at each LDO, one is the LDO output pad

and the second is the corresponding chip supply pad, which

are bonded to the same pin (LDO1 only), and have external

blocking caps (Cblock with low ESR).

If supply should not be generated from the on_chip LDOs,

these blocks can be disabled with control pin PowerUP.

AVDD, DVDD and PVDD can then be forced from external

regulators.

AS3510 Datasheet(PDF) 9 Page - ams AG

AS3510 Datasheet(HTML) 9 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Datasheet Descarga

Enlace URL