MP3908 – HIGH EFFICIENCY BOOST CONTROLLER

NOTICE:

The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

MP3908 Rev. 0.9

www.MonolithicPower.com

11

8/29/2008

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2008 MPS. All Rights Reserved.

PACKAGE INFORMATION

MSOP10

BOTTOM VIEW

0.030(0.75)

0.037(0.95)

0.043(1.10)MAX

0.002(0.05)

0.006(0.15)

FRONT VIEW

0.004(0.10)

0.008(0.20)

SIDE VIEW

GAUGE PLANE

0.010(0.25)

0.016(0.40)

0.026(0.65)

SEATING PLANE

PIN 1 ID

(NOTE 5)

0.114(2.90)

0.122(3.10)

0.187(4.75)

0.199(5.05)

1

5

6

10

0.007(0.18)

0.011(0.28)

0.0197(0.50)BSC

0.114(2.90)

0.122(3.10)

TOP VIEW

NOTE:

1) CONTROL DIMENSION IS IN INCHES. DIMENSION IN BRACKET IS

IN MILLIMETERS.

2) PACKAGE LENGTH DOES NOT INCLUDE MOLD FLASH,

PROTRUSION OR GATE BURR.

3) PACKAGE WIDTH DOES NOT INCLUDE INTERLEAD FLASH OR

PROTRUSION.

4) LEAD COPLANARITY (BOTTOM OF LEADS AFTER FORMING)

SHALL BE 0.004" INCHES MAX.

5) PIN 1 IDENTIFICATION HAS THE HALF OR FULL CIRCLE OPTION.

6) DRAWING MEETS JEDEC MO-817, VARIATION BA.

7) DRAWING IS NOT TO SCALE.

RECOMMENDED LAND PATTERN

0.012(0.30)

0.0197(0.50)BSC

0.181(4.60)

0.040(1.00)