ASDATA1 datasheet(14/32 Pages) AD

14 / 32 page

AD1939

Data Sheet

Rev. E | Page 14 of 32

master clock. In addition, it is especially important that the

clock signal not pass through an FPGA, CPLD, or other large

digital chip (such as a DSP) before being applied to the

AD1939. In most cases, this induces clock jitter due to the

sharing of common power and ground connections with other

unrelated digital output signals. When the PLL is used, jitter in

the reference clock is attenuated above a certain frequency

depending on the loop filter.

RESET AND POWER-DOWN

The function of the RST pin sets all the control registers to their

default settings. To avoid pops, reset does not power down the

analog outputs. After RST is deasserted and the PLL acquires

lock condition, an initialization routine runs inside the

AD1939. This initialization lasts for approximately 256 master

clock cycles.

The power-down bits in the PLL and Clock Control 0, DAC

Control 1, and ADC Control 1 registers power down the

respective sections. All other register settings are retained. To

guarantee proper startup, the RST pin should be pulled low by

an external resistor.

SERIAL CONTROL PORT

The AD1939 has an SPI control port that permits programming

and reading back of the internal control registers for the ADCs,

DACs, and clock system. A standalone mode is also available

for operation without serial control; standalone is configured at

reset by connecting CIN, CCLK, and CLATCH to ground. In

standalone mode, all registers are set to default, except the

internal MCLK enable, which is set to 1. The ADC, ABCLK, and

ALRCLK clock ports are set to master/slave by the connecting

the COUT pin to either DVDD or ground. Standalone mode

only supports stereo mode with an I2S data format and 256 fS

MCLK rate. Refer to Table 11 for details. If CIN, CCLK, and

CLATCH are not grounded, the AD1939 SPI port is active. It is

recommended to use a weak pull-up resistor on CLATCHin

applications that have a microcontroller. This pull-up resistor

ensures that the AD1939 recognizes the presence of a

microcontroller.

The SPI control port of the AD1939 is a 4-wire serial control

port. The format is similar to the Motorola SPI format except

the input data-word is 24 bits wide. The serial bit clock and

latch can be completely asynchronous to the sample rate of the

ADCs and DACs. Figure 11 shows the format of the SPI signal.

The first byte is a global address with a read/write bit. For the

AD1939, the address is 0x04, shifted left one bit due to the R/W

bit. The second byte is the AD1939 register address and the

third byte is the data.

Table 11. Standalone Mode Selection

ADC Clocks

CIN

COUT

CCLK

CLATCH

Slave

Master

D22

D23

CLATCH

CCLK

CIN

COUT

tCCH tCCL

tCDS tCDH

tCLS

tCCP

tCLH

tCOTS

tCOD

tCOE

Figure 11. Format of the SPI Signal

ASDATA1 Datasheet(PDF) 14 Page - Analog Devices

ASDATA1 Datasheet(HTML) 14 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Datasheet Descarga

Enlace URL