VMV3 datasheet(102/212 Pages) MICROSEMI

102 / 212 page

Military ProASIC3/EL DC and Switching Characteristics

2-88

Revision 3

Table 2-159 • Minimum and Maximum DC Input and Output Levels

DC Parameter

Description

Min.

Typ.

Max.

Units

VCCI1

Supply Voltage

2.375

2.5

2.625

VOL

Output Low Voltage

0.9

1.075

1.25

VOH

Output High Voltage

1.25

1.425

1.6

IOL2

Output Lower Current

0.65

0.91

1.16

IOH2

Output High Current

0.65

0.91

1.16

Input Voltage

–

2.925

IIH 3,4

Input High Leakage Current

––

µA

IIL 3,5

Input Low Leakage Current

––

µA

VODIFF

Differential Output Voltage

250

350

450

VOCM

Output Common Mode Voltage

1.125

1.25

1.375

VICM

Input Common Mode Voltage

0.05

1.25

2.35

VIDIFF6

Input Differential Voltage

100

350

–

Notes:

1. ±5%

2. IOL/IOH is defined by VODIFF/(Resistor Network).

3. Currents are measured at 125°C junction temperature.

4. IIH is the input leakage current per IO pin over recommended operating conditions VIH < VIN < VCCI.

Input current is larger when operating outside recommended ranges.

5. IIL is the input leakage current per I/O pin over recommended operation conditions where –0.3 V < VIN <

VIL.

6. Differential input voltage = ±350 mV.

Table 2-160 • AC Waveforms, Measuring Points, and Capacitive Loads

Input Low (V)

Input High (V)

Measuring Point* (V)

1.075

1.325

Cross point

Note:

*Measuring point = Vtrip. See Table 2-28 on page 2-27 for a complete table of trip points.

VMV3 Datasheet(PDF) 102 Page - Microsemi Corporation

VMV3 Datasheet(HTML) 102 Page - Microsemi Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL