MPC5604E datasheet(20/75 Pages) FREESCALE

20 / 75 page

MPC5604E Microcontroller Data Sheet, Rev. 4

Package pinouts and signal descriptions

Freescale Semiconductor

2 Alternate functions are chosen by setting the values of the PCR.PA bitfields inside the SIU module. PCR.PA = 00

 ALT0;

PCR.PA = 01

 ALT1; PCR.PA = 10  ALT2; PCR.PA = 11  ALT3. This is intended to select the output functions; to use

one of the input functions, the PCR.IBE bit must be written to ‘1’, regardless of the values selected in the PCR.PA bitfields.

For this reason, the value corresponding to an input only function is reported as “—”.

3 Module included on the MCU.

4 Multiple inputs are routed to all respective modules internally. The input of some modules must be configured by setting the

values of the PSMIO.PADSELx bitfields inside the SIUL module.

5 Programmable via the SRC (Slew Rate Control) bits in the respective Pad Configuration Register.

6 Additional board pull resistors are recommended when JTAG pins are not being used on the board or application.

7 The 100-pin package is not a production package. It is used for software development only.

8 Do not use ALT multiplexing when ADC channels are used.

MPC5604E Datasheet(PDF) 20 Page - Freescale Semiconductor, Inc