LifecyclePhase:

Revision

: 1

Expired Period: Forever

Release Date:2009-06-15 18:57:03.0

EVERLIGHT ELECTRONICS CO.,LTD.

Technical Data Sheet

7383/R7C3-ARUB/MS

Everlight Electronics Co., Ltd.

http\\:www.everlight.com

Rev 1

Page: 9 of 10

Device Number :

DLE-0001577

Prepared date:06-01-2009

Prepared : Flourix Chen



Wave soldering parameter must be set and maintain according to recommended

temperature and dwell time in the solder wave.

4. Cleaning



When necessary, cleaning should occur only with isopropyl alcohol at room temperature

for a duration of no more than one minute. Dry at room temperature before use.



Do not clean the LEDs by the ultrasonic. When it is absolutely necessary, the influence

of ultrasonic cleaning on the LEDs depends on factors such as ultrasonic power and the

assembled condition. Ultrasonic cleaning shall be pre-qualified to ensure this will not

cause damage to the LED

5. Heat Management



Heat management of LEDs must be taken into consideration during the design stage of

LED application. The current should be de-rated appropriately by referring to the

de-rating curve found in each product specification.



The temperature surrounding the LED in the application should be controlled. Please

refer to the data sheet de-rating curve.

6. ESD (Electrostatic Discharge)



Electrostatic discharge (ESD) or surge current (EOS) can damage LEDs.



An ESD wrist strap, ESD shoe strap or antistatic gloves must be worn whenever

handling LEDs.



All devices, equipment and machinery must be properly grounded.



Use ion blower to neutralize the static charge which might have built up on surface of

the LEDs plastic lens as a result of friction between LEDs during storage and handing.

7. Other



Above specification may be changed without notice. EVERLIGHT will reserve

authority on material change for above specification.