ADRF6518ACPZ-R7 datasheet(31/36 Pages) AD

31 / 36 page

Preliminary Technical Data

ADRF6518

Rev. PrA | Page 31 of 36

Figure 76. Top Layer Silkscreen

Figure 77. Component Side Layout

Table 6. Evaluation Board Configuration Options

Components

Function

Default Conditions

C1, C2, C4, C11, C12, C15, C16,

C30, C31, L1, L2, R2, R3, P4

Power supply and ground decoupling. Nominal supply decoupling

consists of a 0.1 µF capacitor to ground.

C1, C2, C30 = 10 µF (Size 1210)

C4, C11, C12, C15, C16, C31 =

0.1 µF (Size 0402)

L1, L2 = 33 µH (Size 1812)

R2, R3 = 0 Ω (Size 0402)

P4 = installed

T1, T2, C3, C6, C7 to C10, R31,

R32, R43, R44, R45, R46, R47,

R48, R49, R50

Input interface. The INP1_SE, INM1, INP2_SE, and INM2 input SMAs

are used to drive the part differentially by bypassing the baluns.

Using only INP1_SE and INP2_SE in conjunction with the baluns

enables single-ended operation. The default configuration of the

evaluation board is for single-ended operation.

T1 and T2 are 8:1 impedance ratio baluns that transform a single-

ended signal in a 50 Ω system into a balanced differential signal in a

400 Ω system.

R31, R32, R47, R48, R49, and R50 are populated for appropriate

balun interface

T1, T2 = Pulse Electronics

CX2049LNL

C3, C6 = 0.1 µF (Size 0402)

C7 to C10 = 0.1 µF (Size 0602)

R31, R32, R47 to R50 = 0 Ω (Size

0402)

R43 to R46 = open (Size 0402)

ADRF6518ACPZ-R7 Datasheet(PDF) 31 Page - Analog Devices