AD652

REV. B

–7–

Option #4 provides the closest to the ideal transfer function as

diagrammed in Figure 8b. Figure 8c shows the effects on the

transfer relation of the other three options. In the first case, the

slope of the transfer function is unchanged with temperature.

while the slope and offset of the transfer function change with

temperature. If selecting this third option, the user should select

low drift, matched resistors.

Figure 8b. Ideal Bipolar Input Transfer Curve Over

Temperature

Figure 8c. Actual Bipolar Input Transfer Over Temperature

PLCC CONNECTIONS

The PLCC packaged AD652 offers additional input resistors

not found on the cerdip-packaged device. These resistors pro-

vide the user with additional input voltage ranges. Besides the

10 V range available using the on-chip resistor in the cerdip

part, the PLCC device also offers 8 V and 5 V ranges. Figures

9a–9c show the proper connections for these ranges with posi-

tive input voltages. For negative input voltages, the appropriate

resistor should be tied to analog ground and the input voltage

should be applied to Pin 6, the “+” input of the op amp.

Bipolar input voltages can be accommodated by injecting a

250

µA into Pin 5 with the use of the 5 V reference and the

input resistors. For

±5 V or ±2.5 V range the reference output,

Pin 20, should be tied to Pin 10. The input signal should then

be applied to Pin 8 for a

±5 V signal and Pin 7 for a ± 2.5 V

signal. The input connections for a

± 5 V range are shown in

Figure 9d. For a

±4 V range, the input signal should be applied

to Pin 9, and Pin 20 should be connected to Pin 8.

Figure 9.

GAIN AND OFFSET CALIBRATION

The gain error of the AD652 is laser trimmed to within

±0.5%.

If higher accuracy is required, the internal 20 k

Ω resistor must

be shunted with a 2 M

Ω resistor to produce a parallel equivalent

which is 1% lower in value than the nominal 20 k

Ω. Full-scale

Figure 10a. Cerdip Gain and Offset Trim

Figure 10b. PLCC Gain and Offset Trim