WM8912 datasheet(12/128 Pages) WOLFSON

No. de pieza	WM8912

Descripción Electrónicos	Ultra Low Power DAC with Headphone Driver for Portable Audio Applications

PDF	128 Pages

Scroll/Zoom	100%

Fabricante Electrónico	WOLFSON [Wolfson Microelectronics plc]

Página de inicio	http://www.wolfsonmicro.com

Logo

12 / 128 page

WM8912

Production Data

PD, Rev 4.0, September 2010

POWER CONSUMPTION

The WM8912 power consumption is dependent on many parameters. Most significantly, it depends

on supply voltages, sample rates, mode of operation, and output loading.

The power consumption on each supply rail varies approximately with the square of the voltage.

Power consumption is greater at fast sample rates than at slower ones. When the digital audio

interface is operating in Master mode, the DBVDD current is significantly greater than in Slave mode.

(Note also that power savings can be made by using MCLK as the BCLK source in Slave mode.) The

output load conditions (impedance, capacitance and inductance) can also impact significantly on the

device power consumption.

COMMON TEST CONDITIONS

Unless otherwise stated, the following test conditions apply throughout the following sections:

•

Ambient temperature = +25°C

•

Audio signal = quiescent (zero amplitude)

•

Sample rate = 48kHz

•

MCLK = 12.288MHz

•

Audio interface mode = Slave (LRCLK_DIR=0, BCLK_DIR=0)

•

SYSCLK_SRC = 0 (system clock comes direct from MCLK, not from FLL)

Additional, variant test conditions are quoted within the relevant sections below. Where applicable,

power dissipated in the headphone or line loads is included.

WM8912 Datasheet(PDF) 12 Page - Wolfson Microelectronics plc