UCD3138 datasheet(29/68 Pages) TI1

29 / 68 page

Start of Period

Period Counter

Start of Period

Period

Sample Trigger 1

DPWM Output A

Cycle Adjust A (High Resolution)

Event 2 (High Resolution)

Event 1

Event 3 (High Resolution)

Cycle Adjust B (High Resolution)

Event 4 (High Resolution)

DPWM Output B

Blanking A Begin

Blanking A End

Blanking B Begin

Blanking B End

Phase Trigger

Sample Trigger 2

To Other

Modules

To Other

Modules

Multi Mode Open Loop

Events which change with DPWM mode:

DPWM A Rising Edge = Event 1

DPWM A Falling Edge = Event 2 + Cycle Adjust A

DPWM B Rising Edge = Event 3

DPWM B Falling Edge = Event 4 + Cycle Adjust B

Phase Trigger = Phase Trigger Register value

Events always set by their registers, regardless of mode:

Sample Trigger 1, Sample Trigger 2, Blanking A Begin , Blanking A End , Blanking B Begin,

Blanking B End

UCD3138

www.ti.com

SLUSAP2 A – MARCH 2012 – REVISED MARCH 2012

The drawing above is for multi-mode, open loop. Open loop means that the DPWM is controlled entirely

by its own registers, not by the filter output. In other words, the power supply control loop is not closed.

The Sample Trigger signals are used to trigger the Front End to sample input signals. The Blanking

signals are used to blank fault measurements during noisy events, such as FET turn on and turn off.

Additional DPWM modes are described below.

Functional Overview

Submit Documentation Feedback

Product Folder Link(s): UCD3138

UCD3138 Datasheet(PDF) 29 Page - Texas Instruments

UCD3138 Datasheet(HTML) 29 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

Datasheet Descarga

Enlace URL