DLD2 datasheet(59/76 Pages) ITT

No. de pieza	DLD2

Descripción Electrónicos	ZERO INSERTION FORCE CONNECTORS

PDF	76 Pages

Scroll/Zoom	100%

Fabricante Electrónico	ITT [ITT Industries]

Página de inicio	http://www.ittcannon.com

Logo

59 / 76 page

Dimensions are shown in mm (inch)

Dimensions subject to change

ZIF Connectors

Tools and Assembly

Assembly Instructions for Square Post Contacts

Contact Insertion:

Square Post Contacts are factory installed but can

be removed and replaced if damaged in service.

Step 1. Prior to inserting contacts, actuating handle

must be in the maximum

open position. Actuating

handle will be facing toward connector front face,

see Figure 1.

Step 2. Contacts are inserted from the insulator

front face by hand and are seated and clicked in the

cavity by pulling on the terminal post with flat nose

pliers, see Figure 2.

Figure 1

Figure 2

CONNECTOR

FRONT FACE

CONTACT

RETENTION

LANCE

Contact Removal for Square Post Contacts

Tool: CET-ECP and CET-ECP-1

Place tool over square post terminal and impact

tool. Apply sufficient force to collapse retention

lance and push contact out of insulator. This

process destroys the retention lance.

CONTACT

RETENTION

LANCE

DLD2 Datasheet(PDF) 59 Page - ITT Industries