L6726A datasheet(31/35 Pages) STMICROELECTRONICS

No. de pieza	L6726A

Descripción Electrónicos	Single phase PWM controller

PDF	35 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

31 / 35 page

L6726A

5 A demonstration board

Doc ID 12754 Rev 4

31/35

11.1.2

Power output (VOUT)

This is the output voltage of the power conversion. The output voltage is programmed to

1.25 V. It can be changed by replacing R13 (adjusting of compensation network may be

needed). Adding R18 allows to adjust OCP threshold.

11.1.3

IC additional supply (VCC)

The controller can be supplied separately from the power conversion through VCC input. In

this case, to separate VCC from VIN, R16 resistor must be removed.

11.1.4

Test points

The following test points are provided to allow easy probing of important signals:

–

COMP: output of the error amplifier;

–

FB: inverting input of the error amplifier;

–

PH: Phase pin of the device;

–

LG: Low-side gate pin of the device;

–

UG: High-side gate pin of the device.

11.1.5

Demonstration board efficiency

Figure 21.

5 A demonstration board efficiency

100

Output Current [A]

Vin = 12V, Vout = 1.25V

Vin = 5V, Vout = 1.25V

Vin = 12V, Vout = 2.5V

Vin = 5V, Vout = 2.5V

L6726A Datasheet(PDF) 31 Page - STMicroelectronics