UBA2016AP datasheet(10/42 Pages) PHILIPS

No. de pieza	UBA2016AP

Descripción Electrónicos	600 V fluorescent lamp driver with PFC, linear dimming and boost function

PDF	42 Pages

Scroll/Zoom	100%

Fabricante Electrónico	PHILIPS [NXP Semiconductors]

Página de inicio	http://www.nxp.com

Logo

10 / 42 page

UBA2016A_15_15A

All information provided in this document is subject to legal disclaimers.

Objective data sheet

Rev. 1 — 20 May 2011

10 of 42

NXP Semiconductors

UBA2016A/15/15A

600 V fluorescent lamp driver

7.4 Fluorescent lamp control

The IC incorporates all the regulation and control needed for the fluorescent lamp(s), such

as filament preheat, ignition frequency sweep, lamp voltage limitation, lamp current

control, start-up boost, dimming, end-of-life detection, overcurrent protection and hard

switching limiting.

In the UBA2016A/15/15A, 7 different operating states can be distinguished. In each state

the IC acts in a specific way, as described in the next paragraphs. Figure 9 shows the

possible transitions between the states with their conditions.

Fig 8.

Oscillator, driver and half-bridge voltages

tno

time

VCF

time

VGHHB

VSHHB

VSHHB + VVDD

VVDD

VBUS

time

VGLHB

time

VSHHB

001aam537

UBA2016AP Datasheet(PDF) 10 Page - NXP Semiconductors