PIC18F23K22-ESLASHML datasheet(302/496 Pages) MICROCHIP

302 / 496 page

PIC18(L)F2X/4XK22

DS41412C-page 302

Preliminary

 2010 Microchip Technology Inc.

17.3

A/D Acquisition Requirements

For the ADC to meet its specified accuracy, the charge

holding capacitor (CHOLD) must be allowed to fully

charge to the input channel voltage level. The Analog

Input model is shown in Figure 17-5. The source

impedance (RS) and the internal sampling switch (RSS)

impedance directly affect the time required to charge the

capacitor CHOLD. The sampling switch (RSS) impedance

varies over the device voltage (VDD), see Figure 17-5.

The maximum recommended impedance for analog

sources is 10 k

. As the source impedance is

decreased, the acquisition time may be decreased.

After the analog input channel is selected (or changed),

an A/D acquisition must be done before the conversion

can be started. To calculate the minimum acquisition

time, Equation 17-1 may be used. This equation

assumes that 1/2 LSb error is used (1024 steps for the

ADC). The 1/2 LSb error is the maximum error allowed

for the ADC to meet its specified resolution.

EQUATION 17-1:

ACQUISITION TIME EXAMPLE

TACQ

Amplifier Settling Time

Hold Capacitor Charging Time

Temperature Coefficient

TAMP

TCOFF

5µs

Temperature - 25°C

 0.05µs/°C





CHOLD RIC

RSS

 ln(1/2047)

–

13.5pF 1k

 700 10k



–

ln(0.0004885)

1.20

µs

TACQ

5µs

1.20µs

50°C- 25°C

 0.05s/°C





7.45µs

VAPPLIED 1e

–

---------

–







VAPPLIED 1

2047

------------

–





VAPPLIED 1

2047

------------

–





VCHOLD

VAPPLIED 1e

–

----------

–







VCHOLD

;[1] VCHOLD charged to within 1/2 lsb

;[2] VCHOLD charge response to VAPPLIED

;combining [1] and [2]

The value for TC can be approximated with the following equations:

Solving for TC:

Therefore:

Temperature

50°C and external impedance of 10k

 3.0V VDD

Assumptions:

Note 1: The reference voltage (VREF) has no effect on the equation, since it cancels itself out.

2: The charge holding capacitor (CHOLD) is discharged after each conversion.

3: The maximum recommended impedance for analog sources is 10 k

. This is required to meet the pin

leakage specification.

PIC18F23K22-E/ML Datasheet(PDF) 302 Page - Microchip Technology

PIC18F23K22-E/ML Datasheet(HTML) 302 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL