ATSAM3U datasheet(20/62 Pages) ATMEL

No. de pieza	ATSAM3U

Descripción Electrónicos	AT91ARM Cortex M3-based Microcontrollers

PDF	62 Pages

Scroll/Zoom	100%

Fabricante Electrónico	ATMEL [ATMEL Corporation]

Página de inicio	http://www.atmel.com

Logo

20 / 62 page

6430CS–ATARM–09-Apr-10

SAM3U Series

Entering Wait Mode:

• Select the 4/8/12 MHz Fast RC Oscillator as Main Clock

• Set the LPM bit in the PMC Fast Startup Mode Register (PMC_FSMR)

• Execute the Wait-For-Event (WFE) instruction of the processor

Note:

Internal Main clock resynchronization cycles are necessary between the writing of MOSCRCEN

bit and the effective entry in Wait mode. Depending on the user application, Waiting for

MOSCRCEN bit to be cleared is recommended to ensure that the core will not execute undesired

instructions.

5.5.3

Sleep Mode

The purpose of sleep mode is to optimize power consumption of the device versus response

time. In this mode, only the core clock is stopped. The peripheral clocks can be enabled. This

mode is entered via Wait for Interrupt (WFI) or Wait for Event (WFE) instructions with LPM = 0 in

PMC_FSMR.

The processor can be awakened from an interrupt if WFI instruction of the Cortex M3 is used, or

from an event if the WFE instruction is used to enter this mode.

ATSAM3U Datasheet(PDF) 20 Page - ATMEL Corporation