MP3V5010

Sensors

4

Freescale Semiconductor

Pressure

ON-CHIP TEMPERATURE COMPENSATION, CALIBRATION AND SIGNAL CONDITIONING

The performance over temperature is achieved by

integrating the shear-stress strain gauge, temperature

compensation, calibration and signal conditioning circuitry

onto a single monolithic chip.

in the basic chip carrier (Case 482). A fluorosilicone gel

isolates the die surface and wire bonds from the environment,

while allowing the pressure signal to be transmitted to the

sensor diaphragm.

The MP3V5010 series pressure sensor operating

characteristics, and internal reliability and qualification tests

are based on use of dry air as the pressure media. Media,

other than dry air, may have adverse effects on sensor

performance and long-term reliability. Contact the factory for

information regarding media compatibility in your application.

interfacing the integrated sensor to the A/D input of a

microprocessor or microcontroller. Proper decoupling of the

power supply is recommended.

pressure input. Typical, minimum, and maximum output

curves are shown for operation over a temperature range of

0

output will saturate outside of the specified pressure range.

Figure 2. Cross-Sectional Diagram SOP

(not to scale)

Figure 3. Recommended Power Supply Decoupling and Output Filtering

(For additional output filtering, please refer to Application Note AN1646.)

Fluoro Silicone

Gel Die Coat

Wire Bond

Die

P1

Stainless

Steel Cap

Thermoplastic

Case

Die Bond

Differential Sensing

Element

P2

Lead

Frame

+3 V

1.0 μF

0.01 μF

470 pF

GND

IPS

OUTPUT