CS3310

DS82F1

15

ZCEN - Zero Crossing Enable, Pin 1.

This pin enables or disables the zero crossing detection and time-out function used

during analog output level transitions. A high level on this pin enables the zero

crossing detection function. A low level on this pin disables the zero crossing

detection.

PARAMETER DEFINITIONS

Dynamic Range

Full scale (RMS) signal to broadband noise ratio. The broadband noise is measured

over the specified bandwidth with the input grounded. Units in decibels.

Total Harmonic Distortion plus Noise

The ratio of the rms value of the signal to the rms sum of all other spectral

components over the specified bandwidth (typically 10 Hz to 20 kHz), including

distortion components. Expressed in decibels.

Interchannel Isolation

A measure of crosstalk between the left and right channels. Measured for each

channel at the converter’s output with the input under test grounded and a full-scale

signal applied to the other channel. Units in decibels.