ATmega1284P datasheet(55/468 Pages) ATMEL

No. de pieza	ATmega1284P

Descripción Electrónicos	8-bit Microcontroller with 16/32/64/128K Bytes In-Sytem Programmable Flash

PDF	468 Pages

Scroll/Zoom	100%

Fabricante Electrónico	ATMEL [ATMEL Corporation]

Página de inicio	http://www.atmel.com

Logo

55 / 468 page

8152G–AVR–11/09

ATmega164PA/324PA/644PA/1284P

10.2

Internal Voltage Reference

ATmega164PA/324PA/644PA/1284P features an internal bandgap reference. This reference is

used for Brown-out Detection, and it can be used as an input to the Analog Comparator or the

ADC.

10.2.1

Voltage Reference Enable Signals and Start-up Time

The voltage reference has a start-up time that may influence the way it should be used. The

start-up time is given in ”System and Reset Characteristics” on page 334. To save power, the

reference is not always turned on. The reference is on during the following situations:

When the BOD is enabled (by programming the BODLEVEL [2:0] Fuse).

When the bandgap reference is connected to the Analog Comparator (by setting the

ACBG bit in ACSR).

When the ADC is enabled.

Thus, when the BOD is not enabled, after setting the ACBG bit or enabling the ADC, the user

must always allow the reference to start up before the output from the Analog Comparator or

ADC is used. To reduce power consumption in Power-down mode, the user can avoid the three

conditions above to ensure that the reference is turned off before entering Power-down mode.

ATmega1284P Datasheet(PDF) 55 Page - ATMEL Corporation