ATmega128 datasheet(64/386 Pages) ATMEL

64 / 386 page

2467S–AVR–07/09

ATmega128

$F049

out

SPL,r16

$F04A

sei

; Enable interrupts

$F04B

<instr>

xxx

Moving Interrupts

Between Application

and Boot Space

The General Interrupt Control Register controls the placement of the interrupt vector table.

MCU Control Register

– MCUCR

• Bit 1 – IVSEL: Interrupt Vector Select

When the IVSEL bit is cleared (zero), the interrupt vectors are placed at the start of the Flash

memory. When this bit is set (one), the interrupt vectors are moved to the beginning of the Boot

Loader section of the flash. The actual address of the start of the Boot Flash section is deter-

mined by the BOOTSZ fuses. Refer to the section “Boot Loader Support – Read-While-Write

Self-Programming” on page 273 for details. To avoid unintentional changes of interrupt vector

tables, a special write procedure must be followed to change the IVSEL bit:

Write the Interrupt Vector Change Enable (IVCE) bit to one.

Within four cycles, write the desired value to IVSEL while writing a zero to IVCE.

Interrupts will automatically be disabled while this sequence is executed. Interrupts are disabled

in the cycle IVCE is set, and they remain disabled until after the instruction following the write to

IVSEL. If IVSEL is not written, interrupts remain disabled for four cycles. The I-bit in the Status

Note:

If interrupt vectors are placed in the Boot Loader section and Boot Lock bit BLB02 is programmed,

interrupts are disabled while executing from the Application section. If interrupt vectors are placed

in the Application section and Boot Lock bit BLB12 is programed, interrupts are disabled while

executing from the Boot Loader section. Refer to the section “Boot Loader Support – Read-While-

Write Self-Programming” on page 273 for details on Boot Lock bits.

Bit

765

4321

SRE

SRW10

SM1

SM0

SM2

IVSEL

IVCE

MCUCR

Read/Write

R/W

Initial Value

000

0000

ATmega128 Datasheet(PDF) 64 Page - ATMEL Corporation

ATmega128 Datasheet(HTML) 64 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL