PCF8562TTSLASHS400SLASH2 datasheet(15/36 Pages) NXP

No. de pieza	PCF8562TT/S400/2

Descripción Electrónicos	Universal LCD driver for low multiplex rates

PDF	36 Pages

Scroll/Zoom	100%

Fabricante Electrónico	NXP [NXP Semiconductors]

Página de inicio	http://www.nxp.com

Logo

15 / 36 page

PCF8562_3

Product data sheet

Rev. 3 — 2 December 2008

15 of 36

NXP Semiconductors

PCF8562

Universal LCD driver for low multiplex rates

7.11 Data pointer

The addressing mechanism for the display RAM is realized using the data pointer. This

allows the loading of an individual display data byte, or a series of display data bytes, into

any location of the display RAM. The sequence commences with the initialization of the

data pointer by the load-data-pointer command (see Section 7.17). Following this, an

arriving data byte is stored at the display RAM address indicated by the data pointer in

accordance with the ﬁlling order shown in Figure 10. After each byte is stored, the

contents of the data pointer are automatically incremented by a value dependent on the

selected LCD drive mode: eight (static drive mode), four (1:2 mode), three (1:3 mode) or

two (1:4 mode). If an I2C-bus data access is terminated early then the state of the data

pointer will be unknown. The data pointer should be re-written prior to further RAM

access.

PCF8562TT/S400/2 Datasheet(PDF) 15 Page - NXP Semiconductors