AD9520-2SLASHPCBZ datasheet(81/84 Pages) AD

81 / 84 page

AD9520-2

Rev. 0 | Page 81 of 84

Table 60. EEPROM Control

Reg.

Addr

(Hex) Bit(s) Name

Description

B00

[0]

STATUS_EEPROM

(read-only)

This read-only register indicates the status of the data transferred between the EEPROM and the buffer

when 0x01D[7] is set.

[0] = 0; data transfer is done.

[0] = 1; data transfer is not done.

B01

[0]

EEPROM

data error

(read-only)

This read-only register indicates an error during the data transferred between the EEPROM and the buffer.

[0] = 0; no error. Data is correct.

[0] = 1; incorrect data detected.

B02

[1]

Soft_EEPROM

When the EEPROM pin is tied low, setting Soft_EEPROM resets the AD9520 using the settings saved in

EEPROM.

[1] = 1; soft reset with EEPROM settings (self-clearing).

B02

[0]

Enable EEPROM

write

Enables the user to write to the EEPROM.

[0] = 0; EEPROM write protection is enabled. User cannot write to EEPROM (default).

[0] = 1; EEPROM write protection is disabled. User can write to EEPROM.

B03

[0]

REG2EEPROM

Transfers data from the buffer register to the EEPROM (self-clearing).

[0] = 1; setting this bit initiates the data transfer from the buffer register to the EEPROM (writing process);

it is reset by the I²C master after the data transfer is done.

AD9520-2/PCBZ Datasheet(PDF) 81 Page - Analog Devices

AD9520-2/PCBZ Datasheet(HTML) 81 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

Datasheet Descarga

Enlace URL