SH7708 datasheet(187/633 Pages) RENESAS

187 / 633 page

169

• Do not set the internal clock frequency lower than the CKIO pin frequency.

5. The frequency of the peripheral clock (P

φ) becomes:

• The product of the frequency of the CKIO pin, the frequency multiplication ratio of

PLL circuit 1, and the division ratio of divider 2 when the clock operating mode is 0–2

or 7.

• The product of the frequency of the CKIO pin and the division ratio of divider 2 when

the clock operating mode is 3 and 4.

• The peripheral clock frequency should not be set higher than the frequency of the CKIO

pin, higher than 30 MHz(SH7708, SH7708S) / 33.3 MHz(SH7708R), or lower than 1/4

(SH7708, SH7708S) / 1/8(SH7708R) the internal clock (I

φ).

6. The output frequency of PLL circuit 1 is the product of the CKIO frequency and the

multiplication ratio of PLL circuit 1. This frequency should be equal to or lower than 60

MHz(SH7708, SH7708S) / 100 MHz(SH7708R).

× 1, × 2, × 3* or × 4 can be used as the multiplication ratio of PLL circuit 1. × 1, × 1/2, × 1/3*,

and

× 1/4 can be selected as the division ratios of dividers 1 and 2. Set the rate in the frequency

control register. The on/off state of PLL circuit 2 is determined by the mode.

× 3 multiplication

of PLL circuit 1 and

× 1/3 of dividers 1 and 2 are not supported in emulator.

Note:

SH7708R only

8. For more in formation about the range of usable freguencies for each clock operating mode,see

table 9.4.

SH7708 Datasheet(PDF) 187 Page - Renesas Technology Corp