HD64F2149YV datasheet(222/1075 Pages) RENESAS

222 / 1075 page

Section 7 Data Transfer Controller

Rev. 3.00 Jan 18, 2006 page 194 of 1044

REJ09B0280-0300

7.3.12

Examples of Use of the DTC

Normal Mode: An example is shown in which the DTC is used to receive 128 bytes of data via

the SCI.

1. Set MRA to fixed source address (SM1 = SM0 = 0), incrementing destination address (DM1 =

1, DM0 = 0), normal mode (MD1 = MD0 = 0), and byte size (Sz = 0). The DTS bit can have

any value. Set MRB for one data transfer by one interrupt (CHNE = 0, DISEL = 0). Set the

SCI RDR address in SAR, the start address of the RAM area where the data will be received in

DAR, and 128 (H'0080) in CRA. CRB can be set to any value.

2. Set the start address of the register information at the DTC vector address.

3. Set the corresponding bit in DTCER to 1.

4. Set the SCI to the appropriate receive mode. Set the RIE bit in SCR to 1 to enable the reception

complete (RXI) interrupt. Since the generation of a receive error during the SCI reception

operation will disable subsequent reception, the CPU should be enabled to accept receive error

interrupts.

5. Each time reception of one byte of data ends on the SCI, the RDRF flag in SSR is set to 1, an

RXI interrupt is generated, and the DTC is activated. The receive data is transferred from RDR

to RAM by the DTC. DAR is incremented and CRA is decremented. The RDRF flag is

automatically cleared to 0.

6. When CRA becomes 0 after the 128 data transfers have ended, the RDRF flag is held at 1, the

DTCE bit is cleared to 0, and an RXI interrupt request is sent to the CPU. The interrupt

handling routine should perform wrap-up processing.

HD64F2149YV Datasheet(PDF) 222 Page - Renesas Technology Corp