M16CSLASH29 datasheet(67/499 Pages) RENESAS

67 / 499 page

5. Resets

page 43

5.5.2. Limitations on Stop Mode

When all the conditions below are met, the low voltage detection interrupt is generated and the MCU exits

stop mode as soon as the CM10 bit in the CM1 register is set to 1 (all clocks stopped).

• the VC27 bit in the VCR2 register is set to 1 (low voltage detection circuit enabled)

• the D40 bit in the D4INT register is set to 1 (low voltage detection interrupt enabled)

• the D41 bit in the D4INT register is set to 1 (low voltage detection interrupt is used to exit stop mode)

• the voltage applied to the VCC pin is higher than Vdet4 (the VC13 bit in the VCR1 register is 1)

Set the CM10 bit to 1 when the VC13 bit is set to set to 0 (VCC < Vdet4), if the MCU is configured to enter

stop mode when voltage applied to the VCC pin drops Vdet4 or below and to exit stop mode when the

voltage applied rises to Vdet4 or above.

5.5.3. Limitations on WAIT Instruction

When all the conditions below are met, the low voltage detection interrupt is generated and the MCU exits

wait mode as soon as WAIT instruction is executed.

• the CM02 bit in the CM0 register is set to 1 (stop peripheral function clock)

• the VC27 bit in the VCR2 register is set to 1 (low voltage detection circuit enabled)

• the D40 bit in the D4INT register is set to 1 (low voltage detection interrupt enabled)

• the D41 bit in the D4INT register is set to 1 (low voltage detection interrupt is used to exit wait mode)

• the voltage applied to the VCC pin is higher than Vdet4 (the VC13 bit in the VCR1 register is 1)

Execute the WAIT instruction when the VC13 bit is set to set to 0 (VCC < Vdet4), if the MCU is configured

to enter wait mode when voltage applied to the VCC pin drops Vdet4 or below and to exit wait mode when

the voltage applied rises to Vdet4 or above.

M16C/29 Datasheet(PDF) 67 Page - Renesas Technology Corp