USBUF01P6 datasheet(6/9 Pages) STMICROELECTRONICS

No. de pieza	USBUF01P6

Descripción Electrónicos	EMI filter and line termination for USB upstream ports

PDF	9 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

6 / 9 page

Technical information

USBUF01P6

6/9

This confirms the very low remaining voltage across the device to be protected. It is also

important to note that in this approximation the parasitic inductance effect was not taken into

account. This could be few tenths of volts during few ns at the Vinput side. This parasitic

effect is not present at the Voutput side due the low current involved after the resistance Rt.

The measurements done hereafter show very clearly (Figure 7.a) the high efficiency of the

ESD protection:

–

no influence of the parasitic inductances on Voutput stage

–Voutput clamping voltage very close to VBR (breakdown voltage) in the positive way

and -VF (forward voltage) in the negative way

Figure 7.

Remaining voltage at both stages S1 (Vinput) and S2 (Voutput) during ESD

surge.

Please note that the USBUF01P6 is not only acting for positive ESD surges but also for

negative ones. For these kinds of disturbances it clamps close to ground voltage as shown

in Figure 7.b.

a: Positive surge

b: Negative surge

USBUF01P6 Datasheet(PDF) 6 Page - STMicroelectronics