ST70137 datasheet(11/22 Pages) STMICROELECTRONICS

11 / 22 page

ST70137

11/22

PCI_TRDYN

I/O

PCI Target Ready

This signal is driven by the select target to indicate the tar-

get is able to complete the current data phase. During

read transactions, it indicates PCI_AD[] contains valid

data. Wait states occur until both PCI_TRDYN and

PCI_IRDYN are asserted togheter.

PCI_PERRN

I/O

PCI Parity Error

Only for reporting data parity errors for all bus transactions

except for special cycles. It is driven by the agent receiving

data two clock cycles after the parity was detected as an

error. This signal is driven inactive (high) for one clock

cycle prior to returning to the tri-state condition.

PCI_SERRN

PCI System Error

Used to report address and data parity errors on special

cycle commands and any other error condition having a

catastrophic system impact.

PCI_INTAN

PCI Interrupt A

This signal is defined as optional and level sensitive. Driv-

ing it low will interrupt to the host. The PCI_INTAN inter-

rupt is to be used for any single function device requiring

an interrupt capability.

PCI_PMEN

PCI Power Management Event

This signal is used to indicate that a power management

event has been detected. The PCI_PMEN signal is asyn-

chronous with respect to the PCI clock; it is set (if

enabled) by the low to high transition of the ACTD signal.

PCI_STOPN

I/O

PCI Stop

This signal indicates the current target is requesting the

master to stop the current transaction.

USB INTERFACE

DPLUS

I/O

Differential positive USB data input/output.

DMINUS

I/O

Differential negative USB data input/output.

MISCELLANEOUS INTERFACE

GPIO[3: 0]

I/O

General Purpose I/O Bus

These signals are controlled by internal registers located

inside ADSL uP block. At the Power-up, Hardware or

Software Reset the input direction is chosen.

CFG_MEM_SEL

Select Internal [1] or External [0] PCI/USB configuration

memory.

USB_PCIN_sel

Select PCI [0] or USB [1] Interface

Selecting USB interface and if all Test Pins are set to

default value, all the PCI Pads are deactivated. The

power supply for this section can be not provided. The

PCI section is frozen.

Selecting PCI interface the DMINUS and DPLUS has to be

set to the low level (reset mode). The PLL is in power down

and no any clock will be provided to the USB section.

VAUX_D / USB_SP

VAUX Detect when USB_PCIN_sel = [0] or USB SELF

POWERED when USB_PCIN_sel = [1].

Signal Name

Direction

Init Status

Polarity

Signal Description

PIN DESCRIPTION (continued)

ST70137 Datasheet(PDF) 11 Page - STMicroelectronics

ST70137 Datasheet(HTML) 11 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Datasheet Descarga

Enlace URL