4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an

approved 13 amp BS 1363 plug or a suitably fused isolator switch.

If the plug has to be changed because it is not suitable for your socket, or because of

damage, it must be removed and a replacement fitted, following the wiring instructions

shown below. The old plug must be discarded safely, as insertion into a power socket

could cause an electrical hazard

.

If the colours of the wires in the power cable do not agree with the markings on the

plug.

• The BLUE wire must be

connected to the

terminal marked N or

coloured black.

•The BROWN wire must be

connected to the

terminal marked L or

coloured red.

• The YELLOW AND GREEN

wire must be connected

to the terminal marked E

or

or coloured green.

We strongly recommend

that this product is connected to the mains supply through a Residual Current

Device (RCD)

If you are in any doubt regarding electrical installation, you should consult a

qualified electrician.

EXTENSION CABLES

The maximum length of cable should not exceed 25 metres, and the size of

the conductors must be AT LEAST the same size as that on the EPC800.

Ensure that all connections are well clear of the water.

WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS

SUPPLY.

WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE

COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:

BLUE = NEUTRAL

BROWN = LIVE

YELLOW AND GREEN = EARTH

Plug must be BS1363/A approved.

Always fit

Ensure that the outer sheath of

Neutral

(Blue)

Live

(Brown)

Earth

(Green and

a 13 Amp

the cable is firmly held by the clamp

fuse.

Yellow)