SFEC5 datasheet(13/40 Pages) CLARKE

13 / 40 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ADD FUEL

• The engine is certified to run on standard unleaded petrol (E10).

• DO NOT use unapproved petrol such as E85 (85% ethanol/15% petrol).

• DO NOT mix oil with the petrol.

• DO NOT modify the engine to run on alternative fuels

• Mix in a fuel stabilizer, if required, when adding the fuel to the pressure washer

to protect the fuel system from forming gum deposits (see ‘Long Term Storage’

on page 27).

• If the engine doesn’t run correctly after fueling, switch fuel brands.

1. Place the pressure washer on a flat level surface.

2. Turn the pressure washer ‘OFF’ and let it cool for at least two minutes before

removing the fuel cap.

3. Clean the area around the fuel

cap and loosen the fuel cap

slowly to release the pressure.

4. Slowly add unleaded petrol to

the fuel tank. Use extreme

caution not to over fill the tank

above the fill line. This allows

appropriate space for fuel to

expand.

5. Fit the fuel cap and allow any

spilled fuel to evaporate or wipe

clean before starting the engine.

WARNING: ALWAYS REFUEL IN A WELL VENTILATED AREA AWAY

FROM ANY SOURCES OF IGNITION AND HEAT.

WARNING: DO NOT SMOKE WHILE REFUELLING

WARNING: ALLOW THE UNIT TO COOL DOWN BEFORE REFUELLING.

WARNING: DO NOT LEAVE FUEL WITHIN THE REACH OF CHILDREN.

SFEC5 Datasheet(PDF) 13 Page - Clarke International