K9F2G08U datasheet(20/32 Pages) STMICROELECTRONICS

20 / 32 page

Electrical characteristics

ST72681

20/32

7.6

EMC characteristics

Susceptibility tests are performed on a sample basis during product characterization.

7.6.1

Functional EMS (electro magnetic susceptibility)

Based on a simple running application on the product (toggling 2 LEDs through I/O ports),

the product is stressed by two electromagnetic events until a failure occurs (indicated by the

LEDs).

■ ESD: Electro-Static Discharge (positive and negative) is applied on all pins of the device

until a functional disturbance occurs. This test conforms with the IEC 1000-4-2 standard.

■ FTB: A Burst of Fast Transient voltage (positive and negative) is applied to VDD33 and

VSS33 through a 100pF capacitor, until a functional disturbance occurs. This test conforms

with the IEC 1000-4-4 standard.

A device reset allows normal operations to be resumed. The test results are given in the

table below based on the EMS levels and classes defined in application note AN1709.

Designing hardened software to avoid noise problems

EMC characterization and optimization are performed at component level with a typical

application environment and simplified MCU software. It should be noted that good EMC

performance is highly dependent on the user application and the software in particular.

Therefore it is recommended that the user applies EMC software optimization and

prequalification tests in relation with the EMC level requested for his application.

Software recommendations

The software flowchart must include the management of runaway conditions such as:

●

Corrupted program counter

●

Unexpected reset

●

Critical Data corruption (control registers...)

Prequalification trials

Most of the common failures (unexpected reset and program counter corruption) can be

reproduced by manually forcing a low state on the RESET pin or the Oscillator pins for 1

second.

To complete these trials, ESD stress can be applied directly on the device, over the range of

specification values. When unexpected behavior is detected, the software can be hardened

to prevent unrecoverable errors occurring (see application note AN1015).

Table 16.

EMC characterization and optimization values

Symbol

Parameter

Conditions

Level/

Class

VFESD

Voltage limits to be applied on any I/O

pin to induce a functional disturbance

VDD33 = 3.3V, TA = +25°C, fOSC = 12 MHz

complies with IEC 1000-4-2

specifications

VFFTB

Fast transient voltage burst limits to be

applied through 100pF on VDD33 and

VSS33 pins to induce a functional

disturbance

VDD33 = 3.3V, TA = +25°C, fOSC = 12 MHz

complies with IEC 1000-4-4

specifications

K9F2G08U Datasheet(PDF) 20 Page - STMicroelectronics

K9F2G08U Datasheet(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Datasheet Descarga

Enlace URL