4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

• The tool is not in use.

• The air tool will be left unattended.

• Moving to another work area.

14. DO NOT use the tool if it is defective or operating abnormally.

15. DO NOT damage the air tool by applying excessive force.

16. ALWAYS maintain the tool with care for the best and safest performance.

17. Quick change couplings should not be located at the tool. They add

weight and could fail due to vibration.

18. DO NOT force or misuse the tool. It will do a better and safer job at the rate

for which it was designed.

19. This tool vibrates with use. Vibration may be harmful to your hands or arms.

Stop using the tool if discomfort, a tingling feeling or pain occurs. Seek

medical advice before resuming use.

20. When not in use the air tool must be disconnected from the air supply and

stored in a dry place out of the reach of children.

IMPACT WRENCH SAFETY INSTRUCTIONS

1. ALWAYS use the impact wrench as described in these instructions.

2. ALWAYS ensure the wrench is not moving and disconnected from the air

supply when changing sockets etc. Use only Impact Wrench sockets....DO

NOT use standard sockets.

3. ALWAYS finish tightening wheel nuts or engine parts with a torque wrench or

suitable spanner to the correct torque as recommended by the vehicle

manufacturer.

4. ALWAYS avoid excessive use of the wrench. When tightening a nut or bolt,

only allow the wrench to impact briefly to avoid over tightening.

5. ALWAYS ensure that the socket is correctly installed before switching on.

6. ALWAYS use sockets which are specified for impact wrench use.

7. Due to the possible presence of asbestos dust from brake linings, always

wear suitable respiratory protection.

8. ALWAYS disconnect from the air supply when changing sockets or when the

wrench is not required for immediate use in order to avoid accidental

starting.

9. ALWAYS use both hands to control the impact wrench.

10. ALWAYS ensure the wrench has stopped before putting it down after use.