M25P05-AVMP6T datasheet(16/41 Pages) STMICROELECTRONICS

16 / 41 page

M25P10-A

16/41

Read Status Register (RDSR)

The Read Status Register (RDSR) instruction al-

lows the Status Register to be read. The Status

Program, Erase or Write Status Register cycle is in

progress. When one of these cycles is in progress,

it is recommended to check the Write In Progress

(WIP) bit before sending a new instruction to the

device. It is also possible to read the Status Reg-

ister continuously, as shown in Figure 11.

Table 6. Status Register Format

The status and control bits of the Status Register

are as follows:

WIP bit. The Write In Progress (WIP) bit indicates

whether the memory is busy with a Write Status

such a cycle is in progress, when reset to 0 no

such cycle is in progress.

WEL bit. The Write Enable Latch (WEL) bit indi-

cates the status of the internal Write Enable Latch.

When set to 1 the internal Write Enable Latch is

set, when set to 0 the internal Write Enable Latch

is reset and no Write Status Register, Program or

Erase instruction is accepted.

BP1, BP0 bits. The Block Protect (BP1, BP0) bits

are non-volatile. They define the size of the area to

be software protected against Program and Erase

instructions. These bits are written with the Write

Status Register (WRSR) instruction. When one or

both of the Block Protect (BP1, BP0) bits is set to

1, the relevant memory area (as defined in Table

2.) becomes protected against Page Program

(PP) and Sector Erase (SE) instructions. The

Block Protect (BP1, BP0) bits can be written pro-

vided that the Hardware Protected mode has not

been set. The Bulk Erase (BE) instruction is exe-

cuted if, and only if, both Block Protect (BP1, BP0)

bits are 0.

SRWD bit. The Status Register Write Disable

(SRWD) bit is operated in conjunction with the

Write Protect (W) signal. The Status Register

Write Disable (SRWD) bit and Write Protect (W)

signal allow the device to be put in the Hardware

Protected mode (when the Status Register Write

Disable (SRWD) bit is set to 1, and Write Protect

(W) is driven Low). In this mode, the non-volatile

bits of the Status Register (SRWD, BP1, BP0) be-

come read-only bits and the Write Status Register

(WRSR) instruction is no longer accepted for exe-

cution.

Figure 11. Read Status Register (RDSR) Instruction Sequence and Data-Out Sequence

SRWD

BP1

BP0

WEL

WIP

Status Register Write Protect

Block Protect Bits

Write Enable Latch Bit

Write In Progress Bit

3456789 10 11 12 13 14 15

Instruction

AI02031E

6543210

Status Register Out

High Impedance

MSB

6543210

Status Register Out

MSB

M25P05-AVMP6T Datasheet(PDF) 16 Page - STMicroelectronics

M25P05-AVMP6T Datasheet(HTML) 16 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41

Datasheet Descarga

Enlace URL