7 Application and Implementation

Note

Information in the following applications sections is not part of the TI component specification,

and TI does not warrant its accuracy or completeness. TI’s customers are responsible for

determining suitability of components for their purposes, as well as validating and testing their design

implementation to confirm system functionality.

7.1 Power Supply Recommendations

The power supply can be any voltage between the minimum and maximum supply voltage rating located in the

Recommended Operating Conditions. Each VCC terminal should have a good bypass capacitor to prevent power

disturbance. A 0.1-μF capacitor is recommended for this device. It is acceptable to parallel multiple bypass caps

to reject different frequencies of noise. The 0.1-μF and 1-μF capacitors are commonly used in parallel. The

bypass capacitor should be installed as close to the power terminal as possible for best results, as shown in

given example layout image.

7.2 Layout

7.2.1 Layout Guidelines

When using multiple-input and multiple-channel logic devices inputs must not ever be left floating. In many

cases, functions or parts of functions of digital logic devices are unused; for example, when only two inputs of a

triple-input AND gate are used or only 3 of the 4 buffer gates are used. Such unused input pins must not be left

unconnected because the undefined voltages at the outside connections result in undefined operational states.

All unused inputs of digital logic devices must be connected to a logic high or logic low voltage, as defined by the

input voltage specifications, to prevent them from floating. The logic level that must be applied to any particular

unused input depends on the function of the device. Generally, the inputs are tied to GND or VCC, whichever

makes more sense for the logic function or is more convenient.

7.2.2 Layout Example

1

2

3

4

5

6

7

14

13

12

11

10

9

8

1Y

1A

2Y

2A

2B

GND

V

CC

4Y

4B

3Y

3B

3A

GND

V

CC

4A

1B

0.1

F

Unused inputs

tied to VCC

Bypass capacitor

placed close to

the device

Avoid 90°

corners for

signal lines

Recommend GND flood fill for

improved signal isolation, noise

reduction, and thermal dissipation

Unused output

left floating

Figure 7-1. Example Layout for the SNx4LVC02A

SN54LVC02A, SN74LVC02A

SCAS280T – JANUARY 1993 – REVISED DECEMBER 2024

www.ti.com

10

Submit Document Feedback

Copyright © 2024 Texas Instruments Incorporated

Product Folder Links: SN54LVC02A SN74LVC02A