Page 2

Directions for Use

Masking should take place between the cleaning and coating process. PCM should be applied to the area being

masked to a thickness of at least 1mm to enable easy peeling after coating. Dry at room temperature for at

least 2 hours. This can be accelerated by heating to 60°C for 30 minutes but some discolouration of copper

may occur.

Thicker films may require longer drying times. As PCM dries it darkens in colour. PCM must be fully dry before

being coated. After spray, dip or brush application with conformal coating the coating should be air-dried in

accordance with manufacturer's recommendations before PCM is removed.

When the coating is dry, peel off PCM by hand to leave the protected area or component clean and free from

coating. The conformal coating may then be heat cured if applicable.

Note:

This product contains Ammonia. It should be applied and allowed to dry in a well-ventilated area. Store

below 30°C. Please refer to MSDS for further information.

Revision 2: Oct 2016