TS4909_V01 datasheet(28/35 Pages) STMICROELECTRONICS

28 / 35 page

Application information

TS4909

28/35

Doc ID 11972 Rev 9

4.6

Wake-up time

When the standby is released to turn the device ON, the bypass capacitor C

is charged

immediately. As C

is directly linked to the bias of the amplifier, the bias will not work

properly until the C

voltage is correct. The time to reach this voltage plus a time delay of

40 ms (pop precaution) is called the wake-up time or t

. It is specified in the electrical

characteristics tables with C

=1 μF (see

Section 3: Electrical characteristics on page 7).

If C

has a value other than 1 μF, you can calculate t

by using the following formulas, or

read it directly from the graph in

Figure 82.

Single-ended configuration:

Phantom ground configuration:

Figure 82. Typical wake-up time vs. bypass capacitance

Note:

It is assumed that the C

b voltage is equal to 0 V. If the

b voltage is not equal to 0 V, the

wake-up time is lower.

4.7

Pop performance

Pop performance in the phantom ground configuration is closely linked with the size of the

input capacitor C

. The size of C

is dependent on the lower cut-off frequency and PSRR

values requested.

In order to reach low pop, C

must be charged to V

/2 in less than 40 ms. To follow this

rule, the equivalent input constant time (R

) should be less then 8 ms.

in =

<0.008 s

By following the previous rules, the TS4909 can reach low pop even with a high gain such

as 20 dB.

2.5

⋅

0.042

--------------------

[ms;

μF ]

2.5

⋅

0.417

--------------------

[ms;

μF ]

012

345

100

150

200

250

300

350

AMB

=2 5° C

P hantom G round

Cb (μF)

S ingle E nded

TS4909 Datasheet(PDF) 28 Page - STMicroelectronics

TS4909 Datasheet(HTML) 28 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35

Datasheet Descarga

Enlace URL