STMPE1601 datasheet(38/58 Pages) STMICROELECTRONICS

No. de pieza	STMPE1601

Descripción Electrónicos	16-bit enhanced port expander with keypad and PWM controller Xpander Logic

PDF	58 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

38 / 58 page

Basic PWM controller

STMPE1601

38/58

11.1

Interrupt on basic PWM controller

A basic PWM controller can be programmed to generate interrupts at the completion of a

blinking sequence. However, there are some limitations:

Each basic PWM controller has its own bit in the interrupt enable/status registers.

If enabled, completion in any of the PWM controller triggers interrupts. No interrupt

will be generated if infinite repetition is set.

In WDT mode, an interrupt is generated when timeout occurs

In One-shot mode

If Auto-reload, interrupt is generated every time a valid trigger is detected

If Non-auto-reload, an interrupt is generated just once

11.2

Trigger feature

The basic PWM controller can be programmed to be controlled by an external “trigger”

signal. This feature can be used to implement:

●

One shot trigger circuit

●

Watchdog timer

A 120

μS pulse is generated at PWM output when the programmed timer has elapsed

without getting any trigger for the trigger source.

STMPE1601 Datasheet(PDF) 38 Page - STMicroelectronics