PCM1609APT.B datasheet(29/47 Pages) TI2

29 / 47 page

www.ti.com

ANALOG OUTPUTS

f − Frequency − Hz

−100

−80

−60

−40

−20

100

10M

G019

10k

100k

VCOM OUTPUT

–

VCOM

OPA337

µF

PCM1609A

S0054-04

BIAS +

PCM1609A

SLES145B – AUGUST 2005 – REVISED MARCH 2008

The PCM1609A includes eight independent output channels, VOUT1 through VOUT8. These are unbalanced

outputs, each capable of driving 3.1 Vp-p typical into a 5-k

Ω ac load with VCC = 5 V. The internal output

amplifiers for VOUT1 through VOUT8 are dc biased to the common-mode (or bipolar zero) voltage, equal to VCC/2.

The output amplifiers include an RC continuous-time filter, which helps to reduce the out-of-band noise energy

present at the DAC outputs due to the noise-shaping characteristics of the PCM1609A delta-sigma DACs. The

frequency response of this filter is shown in Figure 28. By itself, this filter is not enough to attenuate the

out-of-band noise to an acceptable level for most applications. An external low-pass filter is required to provide

sufficient out-of-band noise rejection. Further discussion of DAC post-filter circuits is provided in the Application

Information section of this data sheet.

Figure 28. Output-Filter Frequency Response

One unbuffered common-mode voltage output pin, VCOM (pin 15), is brought out for decoupling purposes. This

pin is nominally biased to a dc voltage level equal to VCC/2. If this pin is to be used to bias external circuitry, a

voltage follower is required for buffering purposes. Figure 29 shows an example of using the VCOM pin for

external biasing applications.

Figure 29. Biasing External Circuits Using VCOM Pin

Submit Documentation Feedback

Product Folder Link(s): PCM1609A

PCM1609APT.B Datasheet(PDF) 29 Page - Texas Instruments