M68ICS08KX datasheet(19/77 Pages) MOTOROLA

19 / 77 page

M68ICS08KX In-Circuit Simulator

User’s Manual

MOTOROLA

Preparation and Installation

User’s Manual — M68ICS08KX In-Circuit Simulator

Section 2. Preparation and Installation

2.1 Introduction

This section provides information and instruction for configuring, installing,

and readying the M68ICS08KX (KXICS) for use.

2.2 Hardware Preparation

ESD CAUTION:

Ordinary amounts of static electricity from clothing or the work environment

can damage or degrade electronic devices and equipment. For example, the

electronic components installed on the printed circuit board are extremely

sensitive to electrostatic discharge (ESD). Wear a grounding wrist strap

whenever handling any printed circuit board. This strap provides a conductive

path for safely discharging static electricity to ground.

2.2.1 KXICS Limitations

These sub-paragraphs describe system limitations of the KXICS.

2.2.1.1 Bus Frequency

The KXICS communicates using the MON08 features which forces the

communication rate to fbus/256, and the bus frequencies are limited by standard

baud rates allowed by the host software.

2.2.1.2 Port A0

Port A0 is used for communications, so it is unavailable for emulation.

M68ICS08KX Datasheet(PDF) 19 Page - Motorola, Inc