MCP6C26

DS20006928A-page 6

 2024 Microchip Technology Inc. and its subsidiaries

1.0

ELECTRICAL CHARACTERISTICS

1.1

Absolute Maximum Ratings †

VDD -VSS ....................................................................................................................................................... 0V to +6.0V

Current at Input Pins (Note 1) .................................................................................................................................±2 mA

Analog Inputs (VIP and VIM) (Note 1)(Note 2) ..........................................................................................-5.0V to +39.5V

All Other Inputs and Outputs..................................................................................................... VSS - 0.3V to VDD +0.3V

Input Difference Voltage (VDM) (Note 1)(Note 2)....................................................................................................±39.5V

Output Short-Circuit Current............................................................................................................................Continuous

Current at Output and Supply Pins........................................................................................................................±30 mA

Storage Temperature...............................................................................................................................-65°C to +150°C

Maximum Junction Temperature (Note 2) .............................................................................................................+155°C

ESD protection (HBM, CDM).......................................................................................................................... ≥ 2kV, 2kV

Note 1: These voltage and current ratings are physically independent; each required condition must be enforced by

the user (see Section 5.1.2 “Input Voltage/Current Limits”).

2: This condition is intended for intermittent use only.

† Notice: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device.

This is a stress rating only and functional operation of the device at those or any other conditions above those

indicated in the operational sections of this specification is not intended. Exposure to maximum rating conditions for

extended periods may affect device reliability.