XRT86VL32IB datasheet(13/153 Pages) EXAR

No. de pieza	XRT86VL32IB

Descripción Electrónicos	T1/E1/J1 FRAMER/LIU COMBO - ARCHITECTURE DESCRIPTION

PDF	153 Pages

Scroll/Zoom	100%

Fabricante Electrónico	EXAR [Exar Corporation]

Página de inicio	http://www.exar.com

Logo

13 / 153 page

XRT86VL3X

REV. 1.2.2

T1/E1/J1 FRAMER/LIU COMBO - ARCHITECTURE DESCRIPTION

1.2.5

Receive Interface with 1:1 and 1+1 Redundancy

The receivers on the backup card should be programmed for "High" impedance. Since there is no external

resistor in the circuit, the receivers on the backup card will not load down the line interface. This key design

feature eliminates the need for relays and provides one bill of materials for all interface modes of operation.

Select the impedance for the desired mode of operation, T1/E1/J1. To swap the primary card, set the backup

card to internal impedance, then the primary card to "High" impedance. See Figure 5. for a simplified block

diagram of the receive section for a 1:1 redundancy scheme.

FIGURE 5. SIMPLIFIED BLOCK DIAGRAM OF THE RECEIVE INTERFACE FOR 1:1 AND 1+1 REDUNDANCY

"High" Impedence

Internal Impedence

Backplane Interface

Primary Card

Backup Card

XRT86VL3x

T1/E1 Line

1:1

XRT86VL3x

XRT86VL32IB Datasheet(PDF) 13 Page - Exar Corporation