AD5726

Rev. 0 | Page 8 of 20

PIN CONFIGURATION AND FUNCTION DESCRIPTIONS

CLRSEL

16

CLR

15

LDAC

14

NC

13

CS

12

SCLK

11

SDIN

10

GND

9

NC = NO CONNECT

TOP VIEW

(Not to Scale)

AD5726

Figure 5. Pin Configuration

Table 8. Pin Function Descriptions

Pin No.

Mnemonic

Description

1

Positive Analog Supply Pin. Voltage ranges from 5 V to 15 V

2

Buffered Analog Output Voltage of DAC D.

3

Buffered Analog Output Voltage of DAC C.

4

Negative DAC Reference Input. The voltage applied to this pin defines the zero-scale output.

5

Positive DAC Reference Input. The voltage applied to this pin defines the full-scale output voltage.

6

Buffered Analog Output Voltage of DAC B.

7

Buffered Analog Output Voltage of DAC A.

8

Negative Analog Supply Pin. Voltage ranges from 0 V to −15 V.

9

GND

Ground Reference Pin.

10

SDIN

Serial Data Input. Data must be valid on the rising edge of SCLK. This input is ignored when CS is high.

11

SCLK

Serial Clock Input. Data is clocked into the input register on the rising edge of SCLK.

12

CS

Active Low Chip Select Pin. This pin must be active for data to be clocked in. This pin is logically OR’ed with

the SCLK input and disables the serial data input when high.

13

NC

No Internal Connection.

14

LDAC

Active Low, Asynchronous Load DAC Input. The data currently contained in the serial input register is

transferred out to the DAC data registers on the falling edge of LDAC, independent of CS. Input data must

remain stable while LDAC is low.

15

CLR

Active Low Input. Sets input register and DAC registers to zero-scale (0x000) or midscale (0x800),

depending on the state of CLRSEL. The data in the serial input register is unaffected by this control.

16

CLRSEL

Determines the action of CLR. If high, a clear command sets the internal DAC registers to midscale (0x800).

If low, the registers are set to zero (0x000).