SMD Removal

(With solder iron or warm air bath)

•

Apply flux to all leads.

•

Melt CHIP QUIK® uniformly on all pins.

•

Maintain alloy in molten state long enough to release chip.

•

Lift chip from board with dental pick or vacuum pen.

CLEAN UP

•

While molten, use cotton swab and flux to move excess to an unused section of board.

•

While applying heat, polish each pad with a swab and flux until thoroughly clean.

•

At room temperature, clean residue with alcohol pad.

•

You are now ready to install the new chip.

2.5 ft of Chip Quik® material, removes 1250 to 1500 SMD pins.

Conforms to the following Industry Standards:

J-STD-006C, Amendments 1 & 2 (Solder Alloys and Fluxed/Non-Fluxed Solders):

Yes

RoHS 2 Directive 2011/65/EU:

No

2

© 1994-2015 Chip Quik® Inc.