Reminders

Please pay sufficient attention to the warnings for safe designing when using these products.

※ The storage period is less than 12 months. Be sure to follow the storage conditions (Temperature: 5 to 40°C,

Humidity:10 to 75% RHor less).

If the storage period elapses, the soldering of the terminal electrodes may deteriorate.

※ Do not use or store in locations where there are conditions such as gas corrosion (salt, acid, alkali, etc.).

※ Before soldering, be sure to preheat components.

The preheating temperature should be set so that the temperature difference between the solder temperature

and chip temperaturedoes not exceed 150°C.

※ Soldering corrections after mounting should be within the range of the conditions determined in the

specifications.

If overheated, a short circuit, performance deterioration, or lifespan shortening may occur.

※ Self heating (temperature increase) occurs when the power is turned ON, so the tolerance should be

sufficient for the set thermaldesign.

※ Do not expose the products to magnets or magnetic fields.

Do not use for a purpose outside of the contents regulated in the delivery specifications.

Tel: +86 -769 -86761589

http://www.fpe.com.cn