T89C51CC02CA-RATIM datasheet(80/156 Pages) ATMEL

80 / 156 page

AT/T89C51CC02

4126J–CAN–05/06

Working on Message Objects

The Page message object register (CANPAGE) is used to select one of the 4 message

objects. Then, message object Control (CANCONCH) and message object Status

(CANSTCH) are available for this selected message object number in the corresponding

SFRs. A single register (CANMSG) is used for the message. The mailbox pointer is

managed by the Page message object register with an auto-incrementation at the end of

each access. The range of this counter is 8.

Note that the maibox is a pure RAM, dedicated to one message object, without overlap.

In most cases, it is not necessary to transfer the received message into the standard

memory. The message to be transmitted can be built directly in the maibox. Most calcu-

lations or tests can be executed in the mailbox area which provide quicker access.

CAN Controller

Management

In order to enable the CAN Controller correctly the following registers have to be

initialized:

•

General Control (CANGCON),

•

bit Timing (CANBT 1, 2 & 3),

•

And for each page of 15 message objects:

–

Message object Control (CANCONCH),

–

Message object Status (CANSTCH).

During operation, the CAN Enable message object registers (CANEN) gives a fast over-

view of the message objects availability.

The CAN messages can be handled by interrupt or polling modes.

A message object can be configured as follows:

•

Transmit message object

•

Receive message object

•

Receive buffer message object

•

Disable

This configuration is made in the CONCH field of the CANCONCH register (See

Table 54).

When a message object is configured, the corresponding ENCH bit of CANEN register

is set.

Table 54. Configuration for CONCH1:2

When a Transmitter or Receiver action of a message object is completed, the corre-

sponding ENCH bit of the CANEN register is cleared. In order to re-enable the message

object, it is necessary to re-write the configuration in CANCONCH register.

Non-consecutive message objects can be used for all three types of message objects

(Transmitter, Receiver and Receiver buffer).

CONCH 1

CONCH 2

Type of Message Object

Disable

Transmitter

Receiver

Receiver buffer

T89C51CC02CA-RATIM Datasheet(PDF) 80 Page - ATMEL Corporation

T89C51CC02CA-RATIM Datasheet(HTML) 80 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL