AT45DB321D-MU datasheet(2/55 Pages) ATMEL

2 / 55 page

3597H–DFLASH–02/07

AT45DB321D [Preliminary]

sequentially access its data. The simple sequential access dramatically reduces active pin

count, facilitates hardware layout, increases system reliability, minimizes switching noise, and

reduces package size. The device is optimized for use in many commercial and industrial appli-

cations where high-density, low-pin count, low-voltage and low-power are essential.

To allow for simple in-system reprogrammability, the AT45DB321D does not require high input

voltages for programming. The device operates from a single power supply, 2.7V to 3.6V, for

both the program and read operations. The AT45DB321D is enabled through the chip select pin

(CS) and accessed via a three-wire interface consisting of the Serial Input (SI), Serial Output

(SO), and the Serial Clock (SCK).

All programming and erase cycles are self-timed.

Pin Configurations and Pinouts

Figure 2-1.

MLF and CASON

Top View through Package

Figure 2-2.

SOIC Top View

Figure 2-3.

DataFlash Card

(1)

Top View through Package

Note:

1. See AT45DCB004D Datasheet.

Figure 2-4.

TSOP Top View: Type 1

Note:

TSOP package is not recommended for new designs. Future die

shrinks will support 8-pin packages only.

SCK

RESET

GND

VCC

SCK

RESET

GND

VCC

76 54321

RDY/BUSY

RESET

VCC

GND

SCK

AT45DB321D-MU Datasheet(PDF) 2 Page - ATMEL Corporation

AT45DB321D-MU Datasheet(HTML) 2 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55

Datasheet Descarga

Enlace URL