M29DW128F datasheet(17/94 Pages) STMICROELECTRONICS

No. de pieza	M29DW128F

Descripción Electrónicos	128 Mbit (16Mb x8 or 8Mb x16, Multiple Bank, Page, Boot Block) 3V supply Flash memory

PDF	94 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

17 / 94 page

M29DW128F

Signal descriptions

17/94

2.12

VCC supply voltage (2.7V to 3.6V)

VCC provides the power supply for all operations (Read, Program and Erase).

The Command Interface is disabled when the VCC Supply Voltage is less than the Lockout

Voltage, VLKO. This prevents Bus Write operations from accidentally damaging the data

during power up, power down and power surges. If the Program/Erase Controller is

programming or erasing during this time then the operation aborts and the memory contents

being altered will be invalid.

A 0.1µF capacitor should be connected between the VCC Supply Voltage pin and the VSS

Ground pin to decouple the current surges from the power supply. The PCB track widths

must be sufficient to carry the currents required during Program and erase operations, ICC2.

2.13

VSS Ground

VSS is the reference for all voltage measurements. The device features two VSS pins both of

which must be connected to the system ground.

M29DW128F Datasheet(PDF) 17 Page - STMicroelectronics